Sylomer Stud Isolation Mount

Sylomer Stud Isolation Mount
Product Code: Studm
Availability: In Stock
Price: £12.20

Available Options


* EP500:

Qty:        

EP500 Sylomer based Studwork Isolation Mounts

For effective acoustic decoupling of studwork and board from the structure. Secured with pre-drilled holes. These isolation mounts can take loads of up to 60kg per piece and the S35mm Sylomer 'tongue' can be easily cut and a longer S65 tongue option is also available if extra width is required.

The metal footprint is 105 x 48mm with a total height of 21mm. The pre-holes are a 6mm diameter.

The trimable Sylomer tongue is designed to support, and isolate, the plasterboard and other layers as well.

Should be used to isolate the stud head tracks and sidewall tracks / plasterboard as well. That way there is absolutley no physical connection between the rigid materials and the surrounding structural walls/floors/ceilings.

The S35 version has a 35mm tongue and is suitable for double plasterboard and an acoustic membrane with little or no trimming required. The S65 can accommodate far deeper buildups.

Each mount can take a load of up to 60kg.

Mount spacing will depend on the mass of the overall wall. For example a single skin double plasterboard wall with an acoustic membrane would weigh approx. 35kg/m². At 2400mm high this would equate to about 100kg, so two mounts minimum would be needed to cover 1200mm wide but to also support the track (and verticals) it would be better so use 500-600mm spacings. If the wall is heavier, or double skinned, you would need to reduce to 300-450mm spacings depending on overall mass.

stud-isolators-installed

sylomer-stud-installation-drawing

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Noise Control Soundproofing and Acoustics © 2022
View Mobile / Standard