Treadmill Isolation Pads

  • Treadmill Isolation Pads
Product Code: TRE001
Availability: Estimated 5-10 working days
Price: £0.00
Qty:     - OR -   Add to Wish List
Add to Compare

Treadmill Vibration Isolation Pads


If other people are complaining about noise from your treadmill / gym equipment then these pads will solve the problem.

The pads are a mix of vibration isolators made from a superior combination of vibration damping materials. By combining ultra-high performance elastomers with bearing plates, outstanding vibration isolation values are achieved for the most problematic equipment.

Vibration pads are available for any treadmill application. Vibration isolation efficiencies up to 99% and over 40dB reduction are commonly achieved, eliminating noise transfer into other areas.

The Treadmill Isolation Pads are inherently non-slip. The pads are sold by the set which consists of 2 front and 2 rear pads. They are 12.5mm thick.  For other special applications please contact us.

We do not recommend using these if your sub-floor is timber joists. 

Technical Data
Thickness 12.5mm
Standard sizes  
Rear mounts  
Front mounts  

Treadmill running machine isolation pads Application guidlines

Place one pad under each of the four treadmill feet. The floor under the treadmill should be clean and free of debris and all machine cords should have some free play.

Ensure the larger front pads are installed in the front and the smaller rear pads are installed at the back of the unit. Lift the equipment according to the manufacturer's specifications and use proper safety procedures. Lower the treadmill into place and ensure that the foot is centred on the mounts. Please note that even deflection occurred.

Please Note: These units are specifically engineered for solid concrete floors. Using them on timber floors is unlikely to provide the levels of low frequency isolation stated. There may also be secondary issues with sympathetic vibrations when using a treadmill and isolator in a timber floor environment.


Installation guidelines

Treadmill running machine isolation padsProper installation and positioning of the front pads is as follows:

  • With the treadmill at its lowest position, mark the location of the front wheels on the floor.
  • The inserts can be cut and removed to increase the opening aperture size if required.
  • Raise the treadmill to its highest (likely used) height and mark the new location of the front wheels on the floor.
  • Measure the distance between these two points.
  • Divide this measurement by 2.
  • This new measurement represents the distance the levelling wheel must be in front of the centre point in the mount when the mount is being installed on the machine while the machine is at its lowest elevation.
  • Treadmill mounts must be in line with the middle of the levelling wheel and straight and in line with the machine.
  • Treadmill mounts should be checked daily to see if they have moved or been bumped out of position, and returned to their correct position if necessary.
  • The fronot pads must be placed in the centre of gravity. This may not be the middle. If the treadmill is inclined the pads are likely to be over-compressed on one side. The wheel / pad position needs to be adjusted so that the pad is not tilting in any way.

NOTE: If the full travel was 200mm - then while the machine is at its lowest position, the levelling wheel needs to be 100mm in front of the middle of the mount.

Reduces low frequency treadmill noise by 5-15dB between 20-80Hz

treadmill vibration reduction pads installed

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: